SHOWER FLOOR & PAN REPAIR

Shower Floor Repair in Marietta and Atlanta, GA

Water on the ceiling below your shower can point to a failed pan or drain seal. A lasting repair may mean opening the lower walls, correcting the slope and drain connection, waterproofing and re-tiling—not remodeling the entire bathroom.

Prudencio Renovations is a fully insured Georgia licensed residential contractor (RBCO008765), based in Marietta and serving Cobb County and North Atlanta.

Request a quote
Tub to walk-in shower conversion, after renovation (comparison 35)

A completed Prudencio shower project

How to tell what failed

The timing and location of the water provide clues, but the source needs to be confirmed before choosing a repair.

Ceiling stains

Staining below the shower during or shortly after use can point to the pan or drain seal.

Loose or hollow tile

Floor tile that sounds hollow or moves may have lost its bond as water gets behind it.

Recurring grout trouble

Grout that repeatedly fails in one place or water that stays on the floor can indicate a slope problem rather than a sealant problem.

A constant drip

A drip that continues hours after the shower is used is more likely to be plumbing than waterproofing.

Repair or replace?

If the tile, waterproofing and slope are the problems and the rest of the shower works for you, a pan rebuild can cost a fraction of a full remodel. If the shower is 25 years old, the valve is original or replacement was already planned, a full shower replacement may make more sense.

We assess what is there after opening the shower and explain the options; we do not sell a remodel to someone who needs a repair. In many Cobb County showers, a pan repair takes about three to six days, depending on conditions and drying time.

What the repair involves

1. Open and inspect. Remove the floor and the bottom row or two of wall tile to see what is there.

2. Remove and dry. Take out the failed pan and wet substrate; dry the framing.

3. Rebuild. Correct the slope to the drain and waterproof the pan and wall junction.

4. Flood test. Test the pan before tile goes back.

5. Finish. Tie the new tile into the existing walls, grout and seal.

PLANNING YOUR REPAIR

What it costs

$3,000–$6,000

A pan and lower-wall rebuild typically falls in this range, depending on tile choice and how much wall must come out. A full shower replacement with a new valve and glass costs considerably more.

This is a general total-project planning estimate for labor and materials, not a Prudencio labor quote. Homeowners purchase all materials; Prudencio helps with selection and provides labor-only quotes.

See Atlanta bathroom cost ranges

Questions we get asked

Can you match the existing tile?

Sometimes exactly, often closely. If the tile is discontinued, we help you identify the closest option before work starts. Homeowners purchase the materials.

Do I need to move out?

Usually no. You will be without that shower for a few days while work and necessary drying take place.

Will my insurance cover it?

Slow leaks that develop over years are usually not covered, while a sudden failure may be. Check with your insurer; we document the work with photos.

See shower floor repairs we have completed

Explore two examples of shower floor and pan repair work in the Atlanta area.

Water where it should not be?

Send a photo of the ceiling stain and shower floor. We will share our initial thoughts before anyone comes out, then discuss the scope and a labor-only quote.

Request a quote